Merci de choisir local. Expédition gratuite sur commandes de plus de 150$ avant taxes

0

Your Cart is Empty

NOS PRODUITS
  • PROCHAINE FORMATION

  • Sablage & Technique de Correction de Peinture

    Dates à Venir!

  • Sold out

    Race Ramps 56" Single Piece Race Ramps - 10.8 Degree Approach Angle (SKU: RR-56)

    Notify me when this product is available:

    Race Ramps 56" Single Piece Race Ramps - 10.8 Degree Approach Angle (SKU: RR-56)


    Designed to work with low-profile and low-profile cars, the 56-inch Race Ramps offer 8 inches of lift for better access to the lower part of your vehicle. Perfect for lifting the car easily and quickly for work on the front of the car.

    These robust ramps are sold in pairs and can support up to 1500 pounds each for a total capacity of 6000 pounds. Each ramp is also delivered with a carrying strap for easy transport and storage.

    These ramps are manufactured using an exclusive and patented process. They are made of high-density 100% solid foam with a rugged non-slip coating that results in a lightweight ramp solution that is strong but durable. They don’t slip, scratch, damage your floors, and drive heat or cold from the surface to your tires, making them a versatile solution for hot or cold weather applications.


    - Single-piece boom design that lifts 8-inch cars for better access under the hull.
    - Pair of ramps for tires up to 10 wide
    - Approach angle 10.8 degrees


    INSTRUCTIONS FOR USE
    Make sure your ramp is not damaged before using it. Never use two ramps on the same side of the vehicle. Use on a flat surface and ensure that the ramp makes contact with the ground. Make sure your steering wheel is straight and drive at a slow and steady pace. Refer to the instruction manual link to review all instructions for use.

    ASPECTS AND TECHNOLOGIES
    - TIRE WIDTH | 10" maximum width
    - ANGLE OF APPROACH | 10.8 degrees
    - MAXIMUM CAPACITY | 1500 lbs. per ramp
    - SOLD IN PAIR | Set of 2 ramps
    - LIGHT | 10 lbs. per ramp
    - 100% SOLID | Robust high density foam
    - ANTI-SLIP

    Remains in place on any surface (from our experience, avoid surfaces such as wet racedeck tiles. If necessary, add an adhesive rubber edge below your ramps)

    Made in USA